Results 1 - 10
of about 172 for melting.
Search took 0.015 seconds.
1
2
3
4
5
6
7
8
9
10
Next
Sort by date / Sort by relevance
-
... The product of the irradiance and the interaction time is the energy supplied per
unit area or fluence to produce the heating, melting and/or vaporization. ...
http://www.industrial-lasers.com/display_article/172576/39/none/none/Feat/Drilli... - 55k - 2003-03-01
-
... 1. The product of the irradiance and the interaction time is the energy supplied
per unit area. There are three regimes: heating, melting, and vaporization. ...
http://www.industrial-lasers.com/display_article/196902/39/ARCHI/none/Feat/Evolv... - 58k - 2004-01-01
-
... The energy required to bring a volume of steel from room temperature to the melting
temperature comprises “real heat,” transformation heat, and the heat of ...
http://www.industrial-lasers.com/display_article/221991/39/ARCHI/none/Feat/Disc-... - 61k - 2005-02-01
-
... Therefore the eutectic Sn 63 Pb 37 is out of the question despite its good
wetting, low melting point (183°C), and high reliability. ...
http://www.industrial-lasers.com/display_article/330519/39/none/none/Feat/Laser-... - 62k - 2008-06-01
-
... of a pulsed CO 2 laser beam is absorbed over a short interaction length at the surface
of the ceramic, resulting in local heating, melting, and vaporization. ...
http://www.industrial-lasers.com/display_article/310501/39/none/none/Feat/Proces... - 58k - 2007-11-01
-
... The tunnel is created by calcination, the thermal dissociation of CaO3 into CaO
and CO2 at about 825° C. Fluid flow restriction in CaO due to melting is not ...
http://www.industrial-lasers.com/display_article/237163/39/ARCHI/none/Feat/Proce... - 57k - 2005-09-01
-
... Adapting the melting depth to the requirements of the application can be done with
Clearweld absorbers by varying the absorber concentration in the resin. ...
http://www.industrial-lasers.com/display_article/318856/39/ARTCL/none/Feat/Weldi... - 60k - 2008-02-01
-
... Because no welding material is usually employed and welding occurs by partial melting
of the materials in the joint, no carat problems are created as a result ...
http://www.industrial-lasers.com/display_article/247669/39/ARCHI/none/Feat/Laser... - 56k - 2006-02-01
-
... A third method of removing the surface layer is to cause melting and heat
degradation of the concrete near the surface by laser irradiation. ...
http://www.industrial-lasers.com/display_article/232957/39/ARCHI/none/Feat/Betwe... - 62k - 2005-07-01
-
... Both heat sources, CO 2 laser beam and MIG arc, are positioned with an offset to
the face side of the sheets onto the aluminum sheet to avoid melting of the ...
http://www.industrial-lasers.com/display_article/310500/39/none/none/Feat/Lasers... - 61k - 2007-11-01
